TURBOCHARGER SERVICE MANUAL NUMBER 22
Page 7C-20 90-860074--1 FEBRUARY 2002
b. On Engines With O-Ring Seals:
(1.)Being certain surfaces are clean, install a new O-ring in groove of drain/spacer
flange where it meets bearing housing of turbocharger.
(2.)Assemble spacer with bracket attached as shown. Tighten hex nuts finger-tight
at this time.
70998
a
b
c
d
a
b
a-O-ring (Now Shown In Assembled View)
b-Spacer (Oil Drain)
c-Support Bracket
d-Hex Nut
3. Position exhaust housing and bearing housing (with intake housing) as shown.
70999
b
a
a-Exhaust Housing
b-Bearing Housing (With Intake Housing)
To Next Page
Loading...
