Microhard Systems BulletPlus - Page 171

© Microhard Systems Inc. 171
5.0 AT Command Line Interface
AT+MSKAS
Command Syntax (Effect: AT&W)
Get/Set IMCP Keep-alive settings.
AT+MSKAS=<host name>,<interval in seconds>,
<count>
Description
Example
Input:
AT+MSKAS=8.8.8.8,300,20<enter>
Response:
OK
Input:
AT+MSKAS?
Response:
+MSKAS: ICMP
status:0
hostname:8.8.8.8
interval:300
count:20
OK
AT+MNLAN
Command Syntax (Effect: AT&W)
Show/Add/Edit/Delete the network interface.
AT+MNLAN=[<LAN Name>[,<Operation>[,<Protocol>[,STP[,<IP Address>,<Netmask>]]]]]
LAN Name: Name of Network LAN interface
Operation:
SHOW - Show the details of an exsiting LAN interface
ADD - Add a new LAN interface, followed by the other parameters
EDIT - Edit an exsiting LAN interface, followed by the other parameters
DEL - Delete an existing LAN interface
Protocol : 0 - DHCP
1 - Static IP
STP: 0 - Spanning Tree Off
1 - Spanning Tree On
IP Address : Valid IP address
Netmask: Valid netmask
Description
Example
Input:
AT+MNLAN?
Response:
1: lan - 192.168.168.1, static (connection type), On (LAN DHCP), off (STP)
OK