Microhard Systems BulletPlus - Page 181

© Microhard Systems Inc. 181
5.0 AT Command Line Interface
AT+MFGEN
Command Syntax
Get/Set firewall general configuration
AT+MFGEN[=<Config>[,<Mode>]]
Parameters
Config: 0 - WAN Remote Management
1 - WAN Request
2 - LAN to WAN Access Control
3 - Anti-Spoof
4 - Packet Normalization
5 - Carrier Remote Management
6 - Carrier Request
7 - LAN to Carrier Access Control
Mode: 0 - Disable (Block)
1 - Enable (Allow)
Description
Example
Input:
AT+MFGEN=6,0<enter>
Response:
OK
AT+MFDMZ
Command Syntax
Get/Set firewall DMZ configuration
AT+MFDMZ[=<DMZ Source>[,<DMZ Mode>
[,<DMZ Server IP>,<Exception Port>]]]
Parameters:
DMZ Source: 0 - WAN
1 - Carrier
DMZ Mode: 0 - Disable
1 - Enable
DMZ Server IP: Valid IP address
Exception Port: 0 - 65535
Description
Example
Input:
AT+MFDMZ=0,0<enter>
Response:
OK