Microhard Systems BulletPlus - Page 201

© Microhard Systems Inc. 201
5.0 AT Command Line Interface
AT+MASNMPV3
Command Syntax (Effect: AT&W)
Get/Set SNMP version 3.
AT+MASNMPV3=<UserName>,<RWLimit>,<AuthLevel>[,<Auth>,<AuthPassword> <Privacy>
[,<PrivacyPassword>]]
UserName: V3 User Name 1 to 31 characters
RWLimit: V3 User Read Write Limit
0 - Read Only
1 - Read Write
AuthLevel: V3 User Authentication Level
0 - NoAuthNoPriv
1 - AuthNoPriv
2 - AuthPriv
Auth: V3 Authentication Protocol
0 - MD5
1 - SHA
AuthPassword: V3 Authentication Password 1 to 255 characters
Privacy: V3 Privacy Protocol
0 - DES
1 - AES
PrivacyPassword: V3 Privacy Password 1 to 255 characters
Usage:
AT+MASNMPV3=<UserName>,<RWLimit>,0 If <AuthLevel>=0 (NoAuthNoPriv)
AT+MASNMPV3=<UserName>,<RWLimit>,1,<Auth>,<AuthPassword> If <AuthLevel>=1 (Au
thNoPriv)
AT+MASNMPV3=<UserName>,<RWLimit>,2,<Auth>,<AuthPassword>,<Privacy>,<PrivacyPas
sword> If <AuthLevel>=2 (AuthPriv)
Description
Example
Input:
AT+MASNMPV3 <enter>
Response:
+MASNMPV3:
UserName : userV3
RWLimit : Read Only
AuthLevel : NoAuthNoPriv
OK