Microhard Systems BulletPlus - Page 202

© Microhard Systems Inc. 202
5.0 AT Command Line Interface
AT+MASNMPTRAP
Command Syntax (Effect: AT&W)
Get/Set SNMP Trap.
AT+MASNMPTRAP[=<Mode>[,<Name>,<IP>
[,<AuthFailureTraps>]]
<Mode>:
0 - Disable
1 - Enable
<Name>:
Trap Community Name. 1 to 32 characters
<IP>:
Trap Manage Host IP. Default 0.0.0.0 (Disable)
<AuthFailureTraps>:
0 - Disable
1 - Enable
Usage:
AT+MASNMPTRAP
AT+MASNMPTRAP=0
AT+MASNMPTRAP=1[,<Name>,<IP>
[,<AuthFailureTraps>]]
Description
Example
Input:
AT+MASNMPTRAP=1 <enter>
Response:
OK
Input:
AT+MASNMPTRAP?
Response:
+MASNMPTRAP:
Mode : 1 - Enable
Name : TrapUser
IP : 0.0.0.0
AuthFailureTraps : 0 - Disable
OK
AT+MAAUTH
Command Syntax (Effect: AT&W)
Get/Set authentication configuration.
AT+MAAUTH[=<Mode>[,<ServerIP>,
<ServerPort>,<SharedSecret>]]
<Mode>:
0 - Local
1 - Local&RADIUS
<ServerIP>:
Remote Server IP Address
<ServerPort>:
Remote Server IP Port. 0 to 65535. Default 1812
<SharedSecret>:
5 to 64 characters
Usage:
AT+MAAUTH
AT+MAAUTH=0
AT+MAAUTH=1
[,<ServerIP>,<ServerPort>,<SharedSecret>]
Description
Example
Input:
AT+MAAUTH?
Response:
+MAAUTH:
Mode : 1 - Local&RADIUS
ServerIP : 0.0.0.0
ServerPort : 1812
SharedSecret : nosecret
OK