Milestone UltraGROSS - Page 133

UltraGROSS
MM182-001 – Operator Manual
133
Now check that the following pieces shown in the
photo are present.
Insert the drain with seal into the washbasin.
Apply the seal on the other side of the drain.
Insert the two plates as per photo. Then push the
spring into its slot.
Screw on the three screws so that the upper
triangular plate is flush with the seal.
Position the Waste disposal unit on the drain and
secure it by turning the ring nut all the way using
the supplied key. Move the outlet of the waste
disposal unit towards the back of the unit.