USING THE MILLI-Q
Milli-Q Synthesis/Synthesis A10 52
5-6 HOW TO VIEW THE AGE OF THE CONSUMABLES
The Milli-Q Synthesis has 4 consumable items. These include the Q-Gard Pack, the Quantum Cartridge, Millipak
and the UV Lamp.
The Milli-Q Synthesis A10 has 5 consumable items. These include the A10 UV Lamp plus the Q-Gard Pack, the
Quantum Cartridge, Millipak and the UV Lamp.
The age of these consumables can be viewed. The age of a consumable is the number of calendar days that have
passed since the consumable was installed. The age is displayed as a number of days. The number of days will
increase by 1 every 24 hours.
The maximum recommended age of the Q-Gard, Quantum and Millipak is 180 days. The maximum
recommended age of the A10 UV Lamp is 365 days.
The maximum recommended age of the UV Lamp is 365 Days (1 year).
Follow the steps below to view the age of the consumable items.
Press the MENU Keypad button for about 2 seconds. The LCD will change as shown here:
You have entered the ‘Customer Service Software’ of the Milli-Q.
If you do not see this display
, then turn off, then on the system power.
When the LCD shows PRE OPERATE and RECIRCULATION, press the
STANDBY/OPERATE Keypad Button for about 2 seconds. This will place
the Milli-Q into STANDBY Mode. Then press the STANDBY/OPERATE
Keypad Button again. The Milli-Q will now be in PRE OPERATE Mode.
Press the MENU Keypad Button again for 2 seconds to enter the Customer
Service Software.
Press the MENU Keypad Button 2 times.
PRESET V OL U
To Next Page
Loading...
