MIMAKI JFX200-2513 - Replacing Consumables; Replacing the Wiper

4-27
1
1
1
4
Routine Maintenance
Replacing consumables
Replacing the wiper
The wiper is consumable.When the display indicates that it is necessary to
replace the wiper, immediately replace the wiper with a new one.
Also, wipe ink sticking to the lower surface of the slider off.
1
When the message is displayed, press the
key.
2
Press the key.
• The carriage moves on the table.
3
Remove the wiper.
• Pull out the wiper by holding the protrusions at its both ends.
4
Insert a new wiper.
• Insert a new wiper by holding its both ends.
5
Press the key.
• After its initial operation, the machine returns to LOCAL.
• A cleaning wiper is an option.Buy one through the dealer in your region or at our service office.
• Until the replacement work is completed, [COMPLETED [ENT]] is displayed on the
screen. After the work up to the Step 4 is completed, press the key.
<LOCAL>
Rep l a c e a WI PER
[MNT]
REPLACE WI PER
EXECUTE [ ENT ]
REPLACE WI PER
COMP L E T ED [ ENT ]
Projection
Projection
*Be i ng I n i t i a l i zed*
PLEASE WA I T