1-16
Media
Usable media sizes and notes for handling are described.
Usable sizes of media
Caution in handling of medias
Pay attention to the followings for handling of medias.
Model JFX200-2513
Maximum width
2580mm
Maximum length
2040mm
Maximum printing width
2500mm
Thickness
Less than 50mm
Weight
*1
*1. A rough guide is 50 kg per 1 m
2
.
Less than 325kg
• Extension and shrinkage of the media
Do not use the media in the sheet form shortly after the package was opened. The media could
extend or shrink depending on the temperature and humidity inside the room. For more than 30
minutes after opening of the package, the media has to be exposed to the ambient air of the location
it is to be used.
• Warping of the media
As for the media of the sheet form, use the flat one, or the one warping downward (the one with
floating central part when placed the printing surface facing upward.) The media warping upward
could not be absorbed in some cases onto the table. Store the media liable to be warped on the
slightly smaller platform or palette so that it may warp downward.
Be careful not to warp the media out of the absorption area.
• Absorption of the media
To maintain the absorption effect, cover the suction holes not covered by the media with other media
which is thinner than the media.
• Other precautions
a Do not place any article on the surface of the coated paper. Some coated paper could change its
color.
b Curled media that cannot be absorbed or the media that misaligns when the Y-bar is moved may
not be used. Before using, fix the media with adhesive tape, etc.
c Do not use the media that will generate warping or deformation even if the logical seek is set
“OFF”.
d As the bed surface is constructed of multiple boards, their joint lines could be reflected on the
printed images depending on the thickness and elasticity of the media. Similarly, the suction holes
could affect the printed images. Perform the printing after confirming that there is no problem by
making the test printing in advance.
To Next Page
Loading...
