3-6
Registering Head gap value
Set the head gap (height from the media to the nozzle plane of the heads).
When the carriage is to move above the platen for printing or maintenance, it moves while keeping the head
gap at the preset value.
The upper limit of the head gap varies with media thickness.
Available setting values: [1.2 mm to 5.0 mm] (in units of 0.1 mm / Default : 1.5 mm)
1
Press the key in the local.
2
Press to select the [HEAD HEIGHT].
3
Press the key.
4
Press to select the [HEAD GAP].
5
Press the key.
6
Press to set a value of the head gap.
• Set value : 1.2 to 3.0mm
7
Press the key.
8
Press the key several times to end the setting.
How to check the value of the head gap
When you check the head gap value currently set, perform the following procedures:
• If a correct value is not set to the head gap value, the print quality may be deteriorated because of
dropping of large ink droplets on the media at printing
Press the key in Local.
Press the key several times to display [HEAD GAP].
• The head gap value currently set is displayed.
To Next Page
Loading...
