3-17
1
1
3
Convenient use
5
6
Setting Work Cange
Set whether to return to the local mode or keep the remote mode after online drawing.
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [WORK CHANGE].
5
Press the key.
6
Press to select a set value.
OFF : Stays in remote status after online printing. (When the next
printing data has been received, it will be overprinted.)
ON : After online drawing, the Y bar is retracted, and return to the local.
HOST ： If you specify the "PRINT COUNT" to two or more in the RasterLink6 screen, Y bar is retracted
for each print end and return to the local.
7
Press the key.
8
Press the key several times to end the setting.
• Position Y bar is retracted will be the position that set in P.2-18 “Setting the view position”.
To Next Page
Loading...
