MIMAKI JFX200-2513 - Move the Irradiation Position of the UV Lamp

2-8
Move the irradiation position of the UV lamp
When printing with this machine, it is necessary to move the LED UV position according to ink to use (color ink/ white ink).
This machine provides three printing methods:
 Single-layer printing: printing color ink layer on media
 Two-layers printing: printing white ink layer on color ink layer
 Two-layers printing: printing color ink layer on white ink layer
Best-suited position of UV lamp according to printing
This machine is equipped with four UV lamps around the head unit as below.
Depending on the printing method, move the UV lamp.
(1) Adjustment on LUS-150 or LUS-200
4-colors (M/M/K/K/C/C/Y/Y)
Printing method UV lamp position
Single-layer printing: printing color ink layer on media.
• Move the right and left UV lamp to the position at 0mm.
4-colors + white (M/K/C/Y/M/C/W/W), 6-colors + white (M/K/C/Y/Lm/Lc/W/W)
Printing method UV lamp position
Single-layer print that prints color ink layer on media.
• Move the right and left UV lamp to the position at 0mm.
Two layer print that overlap the white ink layer on the color ink
layer.
• Move the right and left UV lamp to the position at 0mm.
Two layer print that overlap the color ink layer on the white ink
layer.
• Move the right and left UV lamp to the position at 65mm.
UV lamp L1
UV lamp L2
UV lamp R1
UV lamp R2
At the front side
At the rear side
Head Unit