2-7
1
2
Basic Operations
4
5
6
Setting a Media
About the media guide hole
There are guide holes into which the attached positioning pin is inserted at the edge of the table (two sides of
upper and lower of the table). Use these as a guide to set the media straight.
• You can attach the M3 screw in the marketplace instead of the attached positioning pin. In this case,
you can attach the screws in two locations at the left and front of the table.
• If you use the attached positioning pin, you cannot use the media of 5mm thickness and below.
• If you print onto media that is no more than 5 mm thick, make sure that the positioning pin has been
removed from the table.
To Next Page
Loading...
