MIMAKI JFX200-2513 - List of Functions

3-7
1
1
3
Convenient use
5
6
List of Functions
This section describes the overview of each function to be set and set values that can be registered in user
types.
• About default “HOST” function
You can operate this by the setting value specified in RIP software.
When you set to other than “HOST”, it operates by that setting value, not by the instruction from RIP
software.
Depending on RIP software, there are some functions that cannot be instructed by software. In such a
case, it operates by the setting value of “When no instruction from RIP exists”.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Set value Default
When no instruction
from RIP exists
*1
*1. This is the setting value to be used for printing when setting value is not specified at the RIP software (host) side, or, you give priority
to the setting value at the machine side, even if you set “Host” to the type registration of this machine.
Outline
DROP. POS CORRECT
(P.3-8)
-40.0 to 0 to 40.0 0.0
Used to adjust the dot position in
go and return printing.
LOGICAL SEEK
( P.3-10) HOST/ ON/ OFF HOST
ON
Sets the scan movable area
during printing.
OVER PRINT ( P.3-21) HOST /1 to 9 HOST
1
Sets the number of layers in
which ink is to be applied.
UV MODE ( P.3-11) HOST/ MANUAL HOST
MANUAL
Sets the UV irradiation pattern
during printing.
REFRESH ( P.3-21)
HOST / Lv.0 (Refresh
interval long) to
3 (Refresh interval short)
HOST
Lv.3
Refreshes the print heads during
printing.
MAPS
(P.3-12)
OFF/MAPS1/MAPS2 MAPS2
Perform setting to reduce stripes
between passes.
MAPS1
PRINT
SPEED
ADJUST
-50 to +50% 0%
MAPS2
AUTO
MANUAL
PATTERN(1 to 5)/
Smoothing level (AUTO/
5 to 100%)
WORK CHANGE ( P.3-17) ON/ OFF/ HOST
Sets the operation when printing
is completed.
IONIZER ( P.3-18) ON/ OFF Sets the optional ionizer.
AUTO
CLEANING
(P.3-19)
OFF, PAGE
PAGE
Sets the automatic cleaning
operation for the head performed
before printing or during printing.
PAGE INTERVAL
1 to 1000 page
3 page
TYPE
NORMAL / SOFT / HARD
SOFT
INTERVAL WIPING ( P.3-20) ON / OFF OFF
Sets the wiping operation during
printing.