3-18
Setting Ionizer
Set the operation when the optional ionizer is installed.
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [IONIZER].
5
Press the key.
6
Press to select a set value.
ON : For normal printing, turn on ionizer before and during
printing to remove electricity. For reverse printing, remove
electricity before printing. Turn on ionizer while shifting to
[View].
OFF : Does not remove electricity.
7
Press the key.
8
Press the key several times to end the setting.
• If you have not installed the optional ionizer, these settings will not appear. If you have installed the
ionizer but these settings fail to appear, contact the distributor or a MIMAKI sales office or call center.
To Next Page
Loading...
