MIMAKI JFX200-2513 - Turning the Power off

2-4
Turning the Power ON/OFF
Turning the Power OFF
When having ended the operation of the machine, turn the power OFF by pressing the power button located on
the front side.
Check the following items when turning the power OFF.
• If the machine is receiving data from the PC or if there is any data that has not been output yet
• If the head has returned to the capping station
• If any error has occurred （ P.5-12 “Error messages”
）
1
Turn OFF the power of the connected PC.
2
Push the power button to turn the power OFF.
• The power supply button goes out.
• To use this machine again, light the green lamp by pressing
the power button.
Cautions about Turning the Power OFF
 Do not unplug from the power outlet.
Leave plugged into the power outlet and periodically turn the power on so that the nozzle clogging
prevention function (flushing function) and the pressure adjusting function operate.
If not plugged into the power outlet, the auto maintenance functions, such as flushing, do not operate,
and this may cause nozzle clogging.
 Turn the power OFF after having checked the position of the head.
If the power is turned OFF in a state where the head has not returned to the capping station, the head
dries, which may cause nozzle clogging.
In this case, turn the power ON again and check that the head has returned to the capping station, and
then turn the power OFF.
 Do not turn the power OFF during printing.
The head may not return to the capping station.
 After having turned the power button OFF, remove the power cable from the outlet.
When turning off the main power switch to move the machine or for countermeasure against the error of
the machine, be sure to push the power supply button on the operation panel. Check that the lamp went
out, and remove the power cable from the outlet.
 Even if you press the emergency switch, the power supply is not turned off.
The emergency switch is to stop the machine when the situation requires emergency stop. Even if you
press the emergency switch, you cannot turn off the power supply.
Power button