Maintaining the Capping Station
4-7
1
1
1
4
Routine Maintenance
Cleaning the around station
It is recommended that the wiper and cap be cleaned frequently in order to maintain the high image quality of
the machine and keep the machine itself in good working order.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [STATION MAINT.], and
then press the key.
• The carriage moves onto the table.
• Cleaning the waste ink tray.
4
Using a waste cloth etc., wipe off ink adhering to
the waste ink tray.
• Clean the grey-colored area in the figure on the right.
• When you cannot wipe off ink because it is firmly fixed,
scrape it with a spatula etc.
5
Wipe off ink adhering to the flushing unit and/or
shutter portions.
• Soak the clean stick in the maintenance cleaning liquid, and
then remove the ink that has adhered . Wipe off so that
cleaning solution for maintenance will not remain.
6
Press the key after the cleaning.
• After its initial operation, the machine returns to step1.
• Clean the station and the area around it about twice a week (it varies, depending on frequency in the
use of the machine).
• If ink remaining in the waste ink tray gets cured due to UV light, ink discharged at flushing cannot be
moved into the waste ink bottle. It is recommended to clean the waste ink tray frequently.
• If the surface of the flushing filter is fluffy, use a
clean stick soaked in the maintenance cleaning
liquid to wipe it clean.
• If it is particularly dirty or the ink has hardened,
replace the flushing filter.( P.4-36)
To Next Page
Loading...
