MIMAKI JFX200-2513 - Setting Logical Seek

3-10
Setting Logical Seek
The motion of Head varies depending on the set of Logical-seek.
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [LOGICAL SEEK].
5
Press the key.
6
Press to select a set value.
• Set value : HOST / ON / OFF
7
Press the key.
8
Press the key several times to end the setting.
• You cannot specify the logical seek at the RasterLink side. When you set this machine to “Host”,
printing will be performed in “LOGICAL SEEK=ON” status.
UNI-DIRECTIONAL BI-DIRECTIONAL
Movement of heads when
LOGICAL seek is OFF
Movement of heads when
LOGICAL seek is ON
UNI-DIRECTIONAL BI-DIRECTIONAL
MACHINE LENGTH MEDIA
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
LOG I CAL SEEK [ ENT ]
LOG I CAL SEEK
:HOST
LOG I CAL SEEK
:ON
SETUP
LOG I CAL SEEK [ ENT ]