3-11
1
1
3
Convenient use
5
6
Setting UV mode
Set the emission pattern and illumination intensity for the UVLED.
1
Press the key in LOCAL.
2
Press to select [SET UP], and the press
the key.
3
Press to select [UV MODE].
4
Press the key.
5
Press to select a set value.
HOST : Applies UV with the emission pattern and illumination
intensity set in the application.
MANUAL : Applies UV with the pattern and illumination intensity
that you set.
6
Press the key.
• When you selected “HOST” in step5, go to step 7. When you selected “MANUAL”, go to step 8.
7
Press to adjust the intensity (LIGHT), then
press the key.
8
Press to select the ink type to be set, then
press the key.
• Set value : Color/ White/ Clear Ink
9
Press to select the scan direction, then
press the key.
• Set value : Bi / Uni
10
Press to select the pattern to be printed,
then press the key.
• Set value : PATTERN 1, 2 ~ / NOPRINT
• If you select “NOPRINT”, no printing will be done when print data is sent - only UV lamp operation will be
carried out.
11
Press to select the emission level, then
press the key.
• Set value : LEVEL 0 to 15 (The higher this value is, the greater the intensity will be.)
12
Press the key several times to end the setting.
To Next Page
Loading...
