Troubleshooting
5-5
1
1
1
1
5
Troubleshooting
If a Message “SHAKE WHITE INK BOTLES” Appears
White ink tends to settle, so you must periodically shake the ink bottles.
If using white ink, a message will be displayed periodically instructing you to
shake the white ink bottle. Follow the procedure below to shake the white
ink bottle.
1
Take out the white ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
2
Set the white ink bottle on the tank, and move the
lever on the tank completely from the right to the
left side.
• Set the ink bottle while moving the lever on the tank
completely to the right.
3
Press the key.
• Before shaking it, check that the cap is firmly closed.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
• Do not ever rotate the ink bottle at all after
setting it into the tank.
Doing so can result in ink leakage.
To Next Page
Loading...
