4-2
Maintenance
Maintain the machine regularly or as necessary so that its accuracy will be maintained and it can continue to be
used for a long time.
Precautions for Maintenance
Pay attention to the following items when maintaining this machine.
About Cleaning liquid
Use the cleaning liquid dedicated for the ink being used.
Maintenance of frame component
When the exterior surfaces of the machine are stained,
dampen a soft cloth with water or a neutral detergent
diluted with water, squeeze it, and wipe the surfaces with
the cloth. Clean dust on the table.
• When using cleaning solution for maintenance, be sure to wear the supplied protective glasses.
• Never disassemble the machine.Disassembling it can result in electric shock hazards or damage to
the machine.
Before maintenance, be sure to turn off the power button, and unplug the power cable; otherwise, an
unexpected accident may occur.
• Prevent moisture from entering the machine. Moisture inside the machine can cause electric shock
hazards or damage to the machine.
• To ensure stable ink jetting, it is necessary for the machine to eject a small amount of ink (flushing)
regularly when a printing (outputting) operation has not been performed for a long time.
• In case you do not use this machine for a long time, be sure unplug the power cable and remove the
set media.
• Make maintenance after the LED UV has been sufficiently cooled, or burn injury may occur.
• Do not use benzene, thinner, or any chemical agent containing an abrasive.Such materials can
deteriorate or deform the surface of the cover.
• Do not apply a lubricant, etc. to any parts inside the machine. Doing so can cause printing failure.
• Be careful that the cleaning solution, ink, etc. not to stick to the cover because this may cause the
surface of the cover to deteriorate or deform.
Type of Ink Applicable maintenance washings
UV ink
Cleaning liquid for maintenance (SPC-0568)
Maintenance cleaning liquid kit (SPC-0569)
To Next Page
Loading...
