MIMAKI JFX200-2513 - Replacing the Waste Ink Tank before the Waste Ink Tank Confirmation Message Is Displayed

Replacing consumables
4-32
Replacing the waste ink tank before the waste ink tank confirmation message is displayed
Set the waste ink information to 0% in the maintenance menu.
1
Perform steps 3 through 6 in "Disposing of waste ink" ( P.4-29) to empty the
waste ink tank.
2
Press the key in LOCAL.
3
Press to select [MAINTENANCE].
4
Press the key.
5
Press to select [InkTankExchange].
6
Press the key.
• When you press the ENTER key, the waste ink information will be
0%.
When you run this menu, it will be the same state as that from the usage to 0% on the previous page.
FUNCT I ON
SETUP [ ENT ]
FUNCT I ON
MA I N T ENANCE [ EN T ]
MA I N T ENANCE
STAT I ON [ ENT ]
MA I N T ENANCE
I nkTankExchange [ENT ]
WA S T E I N K T A N K
=60%