MIMAKI JFX200-2513 - Displaying the Information of this Machine

3-30
Confirming Machine Information
Displaying the Information of this machine
1
Press the key in LOCAL.
2
The information is displayed sequentially with the key .
• The information shown on the below appear.
3
Press the key to return to LOCAL.
To stop the circulation operation and stirring operation during power is OFF
When white ink installed, even if the power supply of the device is turned OFF,
this machine starts in a regular basis and performs the circulation operation
and stirring operation to prevent sedimentation of ink. ( During operation
display the remaining time on the display screen.)
When you want to discontinue the circulation or stirring operation and this
machine to a usable state, please press the key. (Correspondence
with firmware version 1.50 or later)
Press the key to display the selection screen of continuity /
interruption of operations.
To continue the circulation and stirring action:
Press
(return to the display of operation)
To interrupt the circulation and stirring action:
Press
(after the initial operation, display the
local screen)
LUS- 150 MMKKCCKK
REMAIN 99999999
Remaining amount of ink Error (when ink error occurs) Warning (when warning occurs)
Serial No. Version Main PCB information
RECOVERY NOZZLE
LUS- 150 MMKKCCKK
REMAIN 99999999
NON I NK I C
MMBBYYKK
WA R N I N G
Rep l a c e a Wi pe r [MNT ]
SER I AL No .
:********
JFX200 V1 . 00
MR L - I I I V 1 . 9 0
MA I N P CB E P L *
＊：EPL or EPL2
RECOVERY NOZZ LE : *
CONF I RM DETA I LS [ MNT ]
Press the key and confim
the description
CIRCULATION
0:09:40
During circulation operation
AG I TAT I ON
0:12:35
During circulation operation
CIRCULATION
CONT I NUE < > CANCE L
During circulation operation
AG I TAT I ON
CONT I NUE < > CANCE L
During circulation operation