MIMAKI JFX200-2513 - Setting Ink Bottles

1-9
1
Before Use
3
4
5
6
Setting ink bottles
1
Take out the ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
2
Remove the cap of the ink bottle.
3
Attach the specialized cap to the ink bottle.
(1) Set the specialized cap on the bottle.
• The specialized cap that is used differs depending on the type of ink that is set.
• Before shaking it, check that the cap is firmly closed.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
• If using LUS-150, remove the cap
before using a utility knife to open the
seal attached to the bottle. When
opening the seal, make four slices
(eight sections) as shown in the figure
below and fold the flaps into the bottle.
• Fold the seal flaps fully and firmly into
the inside of the bottle. If they are not
sufficiently folded in, ink supply
deficiency could result.
Cover with paper towel firmly and shake ink slowly
Repeat this
Use a utility knife to make four slices
(eight sections) as shown in the figure on
the left and fold the flaps into the bottle.
Cap A Cap B
View of upside-down cap
The edge of Cap B is thicker.
Specialized cap
Type of ink Cap used
LUS-150 ink Cap A
LUS-200 ink Cap B
LH100 ink Cap B
Primer ink Cap B
LUS-120 ink Cap B