MIMAKI JFX200-2513 - Alternative Nozzles for Printing, When Nozzles Missing Can Not be Improved

4-20
Alternative nozzles for printing, when nozzles missing can not be improved
NOZZLE RECOVERY: When nozzles missing can not be improved at specific points, other good nozzles can
be used as alternatives for printing.
The head of this machine consists as the right figure.
You can set the recovery by specifying the nozzle line each for the
H1-2 (Head 1-2).
1
Select [NOZZLE RECOVERY] of the maintenance
menu.
(1) Press the key in LOCAL.
(2) Press to select [MAINTENANCE] and press the key.
(3) Press to select [NOZZLE RECOVERY].
(4) Press the key.
2
Press to select [PRINT] and press the
key.
3
Press the key to start printing.
• The nozzle pattern is printed.
• When you select “ENTRY” in the Step 2, the machine moves to the
nozzle line selection procedures (Step 5) without printing a nozzle
pattern.
• About nozzle line
• This machine is equipped with four
nozzle lines (Line A, Line B, Line C
and Line D) for one head.
Rear
side
of
machin
e
H1
H2
NOZ Z L E RECOVERY
:PRINT
NOZ Z L E RECOVERY
:PRINT [ENT]
** PRINTING **
PLEASE WA I T
Nozzle pattern
H1-A H1-D H2-A H2-CH1-B H1-C H2-B H2-D