MIMAKI JFX200-2513 - Setting MAPS2 Function (4 Color + Special Color Ink)

3-14
9
Press to select pattern to print.
• AUTO : A pattern that matches the print mode will be set
automatically.
• Pattern 1 to 5 : The pattern that you select will be printed.
10
Press the key.
11
Press to change the smoothing level.
• If using media where the ink tends to run, you may be able to
improve image quality by lowering the smoothing level.
• Set Value : AUTO, 5 to 100% (set in units of 5%)
• AUTO : Set the smoothing level automatically depending on printing mode.
• 5 to 100% :
The MAPS2 effect become strong as the set value increase, and become weak as the set value
decrease.
12
Press the key.
13
Press the key several times to end the setting.
Setting MAPS2 Function (4color + special color ink)
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
• MAPS2 effect differs depending on image to be printed. Change the printing pattern and
use it after checking effect in advance.
MAPS 2
PATTERN : 2
MAPS 2
SMOOTH I NG LV . : AUTO
MAPS 2
SMOOTHING LV. : 100%
25% 50% 75% 100%
SETUP
MAPS [ EN T ]
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
MAPS [ EN T ]