Safety Precautions
x
1
2
3
4
5
6
WARNING
Power supply and voltage
• This unit contains parts applied high voltage.Carrying out electrical work by those unauthorized for that work is
prohibited.
• Use it with the displayed power supply specifications. The power-supply voltage of this machine shall be
single-phase 200 to 240 Vac 15 A and less. (You cannot use this machine in the 100V system.)
• Be sure to always disconnect the power plug when performing maintenance in order to prevent electrical
shock. Depending on the device, one minute might be required for condenser discharging time. Be sure to
always wait five minutes or more after disconnecting the power plug before performing any work.
• Be sure to carry out grounding work to prevent electrical shock.
• The main power circuit breaker should be set ON only by personnel with sufficient knowledge about operations
of this unit.
• Do not touch the LED UV unit on or right after the lamp off with bare hands to avoid from burn injury.
Handling the Anti-freezing liquid
• Use the exclusive Anti-freezing liquid by Mimaki ,or the machine may be damaged.
• If the Anti-freezing liquid or Cooling tank water gets on the skin or clothes, immediately wash it off with soap.
If you get the Anti-freezing liquid or Cooling tank water in your eyes, immediately wash your eyes with a lot of
clean water.
Then, consult a doctor as soon as possible.If high temperature Anti-freezing liquid or Cooling tank water gets
on the skin, immediately wash it off with soap and cool with iced water. Then, consult a doctor as soon as
possible.
• Before using the Anti-freezing liquid, be sure to read the Material Safety Data Sheet (MSDS).
• If you swallowed the Anti-freezing liquid or mixed soft water with antifreezing liquid accidentally, try to get to
vomit, and then consult a doctor as soon as possible.
• When unused the Anti-freezing liquid or used Cooling tank water should discard as followings,
Incinerating the fluid which is absorbed to the sawdust or waste cloth.
Entrust them to an industrial waste disposal contractor, clarifying their contents.
• Avoid ignition such as static electricity and impact spark.
• Be sure to wear goggles and gloves for handling the Anti-freezing liquid.
Handling of LED UV unit
• Do not use the LED UV in an ambience with a possibility of catching fire (gasoline, combustible gas spray,
thinner, lacquer, powder dust, etc.). In addition, do not put paper or cloth near or on the LEDUV, or it may
cause fire.or it may cause electrical shock.
• Never look at the LED UV being lit with your naked eyes,or it may cause pain in your eyes or visual
impairment.Be sure to wear safety glasses.
• Do not apply ultraviolet (UV) light directly to your skin,or it may cause irritation on your skin.
• It is recommended to replace the LED UV unit within the rated life.
Disposition of this machine
• When discarding this machine, request the treatment of it for an industrial waste disposal contractor.
• Treat it properly in compliance with regulation in the local area.
To Next Page
Loading...
