Cleaning the Head and the Area around It
4-9
1
1
1
4
Routine Maintenance
6
Wipe ink sticking to the side of the head off with a clean stick.
• Never rub the nozzles.
7
Press the key after the cleaning.
• Clean the wiper until it looks as shown in the photo on
the right.
• If the nozzles have the streaks from the cap rubber,
clean the nozzles as well.
• When you leave during maintenance (or cleaning),
please make sure to complete the cleaning by
pressing key. Without completing the
cleaning, the nozzle part is left uncovered and then
outside light makes the ink cure, which causes nozzle
clogging or the like.
The nozzle part (Never
touch it.)
Clean the side surface of the head (shown in deep gray) with a clean stick.
Clean with a clean stick.
To Next Page
Loading...
