4-18
6
Open, one at a time, the ink port caps on the side
you selected in step 3.
7
Set the air purge jig to the ink port valve.
8
Press the key.
9
Discharge ink or purge air.
• Press the key to release air from the machine, and
completely discharge the ink and other fluids.
• Discharge mixed ink or air completely. When it is discharged
completely, clear ink (not mixed) is discharged.
• The buzzer will keep sounding at a fixed interval while ink is being
discharged.
• After about 15 seconds, ink discharging will stop automatically and
the buzzer will stop sounding.
10
Press the key to weaken ink discharge.
• Press the key to enable ink discharge using minute negative pressure in the machine so that
ink cannot easily leak. Be sure to always press the key so that minute negative pressure is
applied in the machine before attaching or removing the jig.
• Be sure to carry out air purging on only one port
at a time.
• Do not open the port cap at the side you did not
select in the Step 3. If you open the cap, air is
mixed from here.
• When the valve is hard to open, use the
attached longnose pliers and open.
• There is a magnet attached to the air purge jig’s
bottle. When attaching the bottle to the unit,
attach the bottle to a lower position if possible.
To Next Page
Loading...
