6 - 68 Operator’s Manual
6 Image Acquisition
6. Repeat steps 3 to 5 to acquire all the necessary images.
7. After all views are finished, the system will prompt you to exit iWorks. Tap [Yes] to exit.
6.17.1 Screen Display
The monitor displays the following screen:
6.17.2 View Operation
In iWorks status, you can perform view selection, repeat, replacement and delete operations using
the touch screen.
For some views, the system switches to the relevant imaging modes if necessary.
The comment for the current view has been automatically added to the bottom-left corner of the
image, ready for you to scan the specified anatomy.
View Selection
Tap [Prev]/[Next] to select the view to be scanned. The current view is surrounded by a solid frame.
View Operation
In the current active view, you can perform image scanning, measurements, and adding comments
and body marks, etc. Operations are the same as those for manual operation. See the relevant
chapters for details.
Repeat View
If the current view has been performed, you can touch [Repeat] to insert another template of the
current view and then perform an extra examination. If the current view has not been performed,
you can touch [Repeat] to insert another template of the previous view.
View Replacement
The previous image will be deleted and replaced by the new image.
1 Displays the protocol name, and the number of views contained.
2 Displays the view steps in the protocol.
The current active view with a solid frame around the image.
To Next Page
Loading...
Need help?
General
