Mindray Resona R9 Exp User Manual

3 System Preparation
Operator’s Manual 3 - 13
3.8.3 Connecting a Graph/Text Printer
NOTE:
• Unless otherwise specified, printers listed in Chapter “2.6.4 Peripherals Supported” have
drivers installed already.
• Please refer to the accompanying manuals of the printers for more details.
To add a local printer
As shown in the figure below, a graph/text printer has a power cord and data cable. The power cord
shall be directly connected to a wall receptacle as required.
Perform the following procedure:
1. Connect the data cable to USB port of the ultrasound device.
2. Power on the system and the printer.
3. Put the installation optical disk of the printer driver into the drive.
4. Install the printer driver: Select [Setup] > [Print] > [Add Printer].
All the operations are finished with right <Set> button.
5. Select [The printer that I want isn't listed].
6. Select [Add a local printer or network printer with manual settings] and click [Next] to enter
the following screen.
See the printer's operation manual to select the port, or use the default port of the system.
7. Click [Have Disk] to find the driver path (the installation type should be WIN64), and then
click [Next] to install the driver.
8. Complete the operation according to the tips on the screen. Click [Finish] to end the
installation.
To Add network printer
Perform the following procedure:
1. As the system is connected into a LAN, open [Setup] > [Print] screen.
2. Click [Add Printer] and select [The printer that I want isn't listed] > [Add a Bluetooth, wireless
or network discoverable printer].
1 Power supply cable Connect to power supply.
2 Data cable Connect to the USB port of this system.
1
2

Mindray Resona R9 Exp Specifications

General

Brand	Mindray
Model	Resona R9 Exp
Category	Diagnostic Equipment
Language	English