7 - 38 Operator’s Manual
7 3D/4D
– Tap [Next Slice]/[Previous Slice] to go to the next or previous slice.
– Tap [Undo], [Redo] or [Undo All] to undo, redo or cancel previous editing.
c. Tap [Update Vol] to calculate the volume based on the new contour.
If necessary, tap [Undo], [Redo] or [Undo All] to undo, redo or cancel previous
measurement.
5. Tap [Accept Result], and the measurement results are saved in the report.
7.15.3 Other Operations
Parameter adjusting
•Brightness
– Adjusting the brightness of the images.
– Rotate [Brightness] to adjust the parameter.
•Thickness
– Rotate [Thickness] to adjust the parameter.
– The bigger the value is, the more the thickness information appears.
• 3D iClear
– Tap [3D iClear] to adjust the parameter.
– The bigger the value of iClear is, the less the noise becomes.
Reset
• All planes
Acquire 3D data. Tap [S-Planes CNS] to enter the automatic detection of the mode. Reset the
following operations:
– Tap [All Planes] to reset the planes. The position and the angle to TCP, TTP, TVP, MSP
and reference line return to the initial condition.
– Tap [All Planes] to reset the planes. The position to TCP, TTP, TVP, MSP and reference
line returns to the last MSP condition. The angle to CP, TTP, TVP, MSP and reference line
returns to 0°.
• Current plane
Acquire 3D data. Tap [S-Planes CNS] to enter the automatic detection of the mode. Reset the
following operations:
– Tap [Current Plane] to reset the plane. The position of the current plane returns to the
initial condition. The angle of the current plane returns to 0°.
– Tap [Current Plane] to reset the current plane. The position and the angle to the current
plane returns to the last MSP condition.
Other related Operations
• Hiding the reference
Tap to hide or show the reference line.
• Hiding the measurement
Tap to hide or show the measurement.
• Switching between the single and quad-split display
Tap [Single]or [Quad] between the single and quad-split display.
To Next Page
Loading...
Need help?
General
