Minebea Intec CAS-SPC Series - Multi-interval and Unit Configuration; Multi-interval Mode Setup; Selecting and Configuring Units; Calibration;Adjustment Unit Selection

Multi-interval Mode The illustration shows an example of the input menu opened for multi-interval
mode range conguration. This example shows the parameters for a scale in
“Veriable” conguration, with 2 weighing ranges and a maximum capacity of
6.000 kg.
– Range 1: 0…3.000 kg with e1 = 0.001 kg
– Range 2: 3.002…6.000 kg with e2 = 0.002 kg
t Enter the verication scale interval for Range 1 in the “
E“ input eld.
The minimum capacity for a class l scale must be set to 0.02 kg.
t Use the “o“ soft key to go to the next menu level.
y The active range conguration is marked with “o.“
t Use the “o“ soft key to go back to the “Verifiable“ menu.
Selecting Units t Use the “q“ and “O“ soft key to open the “Available units“
menu item.
This menu lets you enable or disable the weight units available under “Weight
unit 1,“ “Weight unit 2“ and “Weight unit 3.“
t Select the respective unit using the “Q“ or “q“ soft key and conrm using the
“l“ soft key.
In most cases, you will not need to change dened values.
Available weight units are marked by a *.
The weight unit used for conguration of weighing ranges cannot be blocked.
t Use the “o“ soft key to go back to the “Internal“ menu.
t Use the “q“ and “O“ soft key to open the “Calibration/
adjustment
“ menu.
t Use the “q“ and “O“ soft key to open the “Calibration/
adjustment unit
“ menu item to dene the weight unit for
calibration and adjustment. In most cases, you will not need to change dened
values .
y All units are displayed in the menu that are activated in “Available
units
.“ The current setting is marked by a “o.“
Operating Instructions Combics Complete Scales 29
Configuring Weighing Platforms