Minebea Intec CAS-SPC Series - Device Parameter Settings; Device Parameter Configurations

Device Parameters
Password Protection Access to device and application parameters can be password-protected against
unauthorized changes in the Setup menu under “Device parameters:
Password,“ see the “Setting up Password Protection“ section in the “Operat-
ing Design“ chapter.
Acoustic Signal An acoustic signal (single beep for active, double beep for inactive keys) is emitted
when you press a key.
The acoustic signal can be turned on/o and linked to the green LED in
the Setup menu under “Device parameters:Operating
parameters:Acoustic signal
.“
Keys Keys can be blocked/unblocked in the Setup menu under “Device
parameters:Operating parameters:Keys
.“ The following
settings are available:
– All keys unblocked (default setting)
– All blocked except e and H
– Alphanumeric keys blocked
– n blocked
– ( blocked
– ) blocked
– k blocked
– J blocked
– p blocked
– K blocked
– L blocked
– c blocked
– Soft key 1…5 blocked
– D blocked
– H blocked
– c blocked
Automatic Shuto of Combics You can specify that the indicator will shut o after a set time has elapsed in the
Setup menu under “Device parameters:Operating
parameters:Automatic shutoff
,“
Display Lighting The following settings can be made for display lighting in the Setup menu under
“Device parameters:Operating parameters:
Display
:“
– Contrast
– Backlighting
– Model
Timer The timer used to turn the device and/or display lighting on/o can be set to 2, 4,
or 10 minutes in the Setup menu under “Device parameters:
Operating parameters:Timer
.“
80 Operating Instructions Combics Complete Scales
Operation