82
⑧ Communication error processing
This unit returns the error command to the host side when the communication error or the execution
error occurs.
2 4 6 8
@ 0 0 E R 0 1 Terminator
Error
command No.
Contents Remarks
01 Non-executable error
In the calibration mode, the function mode or the check
mode.
02
Other errors by
convenience of this unit
When the receiving command cannot be executed.
10 Parity error At the parity detection error.
11 Fleming error At the stop bit detection error.
12 Over run error At the receiving command reading error.
13
Data code and data
lengthy error
When neither the received data code nor data length are
corresponding.
14 No pertinent command When the receiving command is not corresponding.
13-3-13. Data format of stream mode synchronous with printing.
① When the setting of function F-41 is set with gross weight and net weight
Return (CSD-904-EX → Host)
2 4 6 8 10 12 14
@ 0 0 99 Terminator
2 4 6 8 10 12 14
@ 0 0 9 9 ― 123Terminator
● The error command is not replied when Address and the completion code(terminator) cannot be detected.
● Please consider dealing on the host side when the communication error command is replied from this unit.
● The load data enters from the right.
● The sign of “－” for minus and “＋” for plus is entered.
● The load data performs zero suppress.
● The decimal point adheres to a specified position when the decimal point is set with F-46 and when decimal point is specified with CF-01.
● “OL” is appeared in the load data section at the over load.
● The empty sections are all spaces.
Address
00～31
Error command No.
Command No.
Sign of Load data
Load data
To Next Page
Loading...
Need help?
General
