MIR 200 - Warning Label; Residual Risks

3. Safety
MiR200 User Guide (en) 10/2020 - v.3.1 ©Copyright 2017-2020: Mobile Industrial Robots A/S. 27
NOTICE
If the robot is misused, the warranty becomes void. Only use the robot as
described in Intended use on page24.
3.6 Warning label
MiR200 is supplied with a warning label that specifies that it is strictly prohibited to ride on
the robot.
The label must be placed on the robot or top module so that it is clearly visible.
Figure 3.1. The warning label must be placed on the robot or top module.
3.7 Residual risks
Mobile Industrial Robots has identified the following potential hazards that commissioners
must inform personnel about and take all precautions to avoid when working with MiR200:
• You risk being run over, drawn in, trapped, or struck if you stand in the path of the robot
or walk towards the robot or its intended path while it is in motion.
• You risk being run over, drawn in, trapped, or struck if you stand in the path of the robot
or walk towards it while it is driving in reverse. It will only drive in reverse when
undocking from a marker such as a charging station or load transfer station.
• You risk being crushed or trapped if you touch the robot while it is in motion.
• You risk being crushed or trapped if the robot places a load outside a designated drop-off
area due to faulty localization.
• You risk losing control of the robot if it is accessed by unauthorized users. Consider
increasing the IT security of your product—see IT security on page52.