5. Battery and charging
MiR200 User Guide (en) 10/2020 - v.3.1 ©Copyright 2017-2020: Mobile Industrial Robots A/S. 47
To charge MiR200 using the cable charger, connect the cable charger to the charging
interface on the robot in the rear-left corner. Follow these steps to do this:
1. Remove the rear corner by pulling it towards you. You may have to apply a bit of force
the first couple of times.
2. Attach the charger to the robot’s charging socket and to a power outlet. Turn on the
rocker switch on the robot to begin charging.
Use only the original charging cable.
To Next Page
Loading...
