Additional Features
> General. You can also set a Preferred Line Timeout parameter that specifies the number of seconds it
takes for the phone to switch back to the preferred line.
The following table provides the behavior of the preferred line focus feature with other features on the
phone:
Phone Feature Preferred Line Behavior
Last Call Return The phone switches back to the focused line
immediately after the call ends.
Speeddial The line is already specified when the speed dial
is created. The phone switches back immediately
after the call ends.
Conference For incoming calls, the phone switches back
immediately after the call ends.
Transfer For incoming or outgoing calls, the current
behavior is that the same line used to transfer
the call does not change. For incoming calls, the
phone switches back immediately after the call
transfers.
Park The phone switches back immediately after the
call ends.
Voicemail The phone switches back immediately after the
call ends.
Outgoing Redial The phone switches back immediately after the
call ends.
Dialing For incomplete dialing on a non-preferred line, the
focus does not change if some digits are entered.
If no digits are entered or digits were cleared, the
focus changes to preferred line after the time out
has passed without activities.
Caller ID If the Switch UI Focus To Ringing Line parameter
is disabled, the User is able to see the Caller ID
when the phone switches the focus to the ringing
line.
Version 1.0
173 User Guide
To Next Page
Loading...
