Mitel SX-200 - Cable Terminations, SX-100

_( .,.
$j
:_
.,_’
:.
‘:
!. ,.
,
SECTION MITL9105/911
O-096-350-NA
Cl.09
When backplane translator boards are used with the lines and
trunk circuits, different terminal connections result. In this case,
the cabling arrangements must conform to the termination connec-
tions shown in Figure Cl-8 and Table Cl-6 of this Appendix.
Cl.10 Figures Cl-g,
Cl-10 and Cl-11 are in-depth wiring explana-
tions. These figures outline the card position in relation to a
specific Amphenol-type connector to the cross-connect frame.
1 c
. -
Page C-3