Mitel SX-200 - Extended Programming Toll Control Confirm Codes; Extended Programming Speed Call Error Codes

,^ . .
(.
SECTION MITL91 OS/91 1 O-096-350~NA
TABLE 4-8
EXTENDED PROGRAMMING TOLL CONTROL CONFIRM CODES
Error
c5
Applies to:
Control Plan mode
Table mode
Meaning
An attempt was made to assign a table which is
currently assigned elsewhere. Pressing the
confirm key will de-assign the table from
wherever it was previously assigned, to assign it
to the specified place.
C6 Table mode
A request has been made to delete all entries in
a table. If CONFIRM is pressed, all entries will be
de-assigned. The old data in the non-volatile
RAM will not be destroyed until the ENTER button
is pressed, and the table itself can be
reprogrammed as desired before the ENTER
button is used.
TABLE 4-9
EXTENDED PROGRAMMING SPEED CALL ERROR CODES
.-.
. . . .
Error’
El
El
Applies To:
EQPT
NUMBER
NUMBER
REDIAL
Meaning
The equipment number entered is outside the
range of valid numbers.
An invalid number redial value was entered.
E3
TABLE The table number entered is not consistent with
that allowed.
E4
E4
E5
E5
EO
ACCESS
NUMBER
NUMBER
REDIAL
ACCESS
NUMBER
NUMBER
REDIAL
An attempt was made to enter an access number
for common-use table.
An attempt was made to enter a number redial
digit for a common-use table.
GThe access number entered already exists for
another table assigned to the same equipment
number.-
w
Number redial already exists for another table
assigned to the same equipment number (only
one number redial attribute per user is allowed).
System Option not enabled
or
Wrong key pressed
Page 45