Mitel SX-200 - Attendant UCD Access Codes

SECTION MITL91 OS/91 1
O-096-350-NA
.::
:_..
._ -. ,,.-:
i ..
TABLE 4-13
ATTENDANT UCD ACCESS CODES
To program a RAD from the console:
Dial ~230
Dial RAD equipment number
Dial x to advance to next equipment number
Press RELEASE to terminate.
To program a RAC from the console:
Dial ~231
Dial RAC equipment number
Dial x to advance to next equipment number
Press RELEASE to terminate.
To delete a RAD ~230 <nnn>#, Cancel then Release.
To delete a RAC ~231 <nnn>#, Cancel then Release.
nnn= Eq#
To review all defined RADs and RACs:
Dial ~232
Continue to dial x to advance to next RAD/RAC
Press RELEASE to terminate.
The SOURCE display will show the equipment number in the left corner
ant
a 0 or 1 in the right corner to indicate a RAD or RAC, respectively.
To record a message on the MITEL RAC, the following procedure is used:
Dial ~240
Dial RAC equipment number
Dial *
When the attendant hears a 50 ms tone, the message may be spoken
intc
handset. The recording can be up to 8 seconds in duration.
Press RELEASE to terminate.
To playback a recorded message from a RAC:
Dial ~241
Dial RAC equipment number
Dial x
Message will be heard with handset; otherwise busy tone will be heard if
thf
recording is currently in use.
Press RELEASE to terminate.
The length of the messages on the devices in each Recording Group must
bf
specified:
Dial ~242
Dial Recording Group access code recording duration, in ‘L-digit seconds
Press RELEASE to terminate.
Page 51