Mitel SX-200 - Error Codes

:
.s-
:__
SECTION MITLSlOW911 O-096-350-NA
TABLE 4-4
ERROR CODES
Code Major/
Minor
EOO 1 majort/
minor
E002 major+/
minor
E003 major
Slot
20
20
19
Reason
First three digits Last three digits See
of Destination of Destination Note
Display Display
Error in RAM
Hi byte of bits found in
7.
address error
PROM
000 to 020 PROM
7.
checksum error
Page number
Clock/scanner
1 = 1st interrupt
missing, 2 = 2nd
interrupt missing
E004 minor
18 Speech path
check circuit not
“hi” when
disconnected
1.
E005 minor
18 Bias circuit not Speech path
2.
connected to
number
Speech path
E006 minor 99 Speech path
Speech path that other Speech 2.
(slot
short has bias applied path number
not on which bias
known) was seen
E007 minor 18 Dial tone
circuit not
connected to
speech path
Speech path
number
2.
E008 minor Receiver Receiver not
Receiver
Card receiving tone
equipment
digits number
3.
E009 minor Receiver Receiver not
Receiver 3.
Card receiving pulse equipment
digits number
EOIO minor 18 Generator error Generator
4.
number (1 and 2 are
tone, 3 and 4 are
pulse)
TDuring Power-Up sequence only.
Page 37