SECTION MITL9105/911 O-096-350-NA
_. :I::
APPENDIX E
SX-200 MECHANICAL PRQCEDURES
GENERAL
El.01 The MAPS contained in this Appendix detail the procedures to
be performed in all mechanical work on the SX-200 system.
These MAPS are used in conjunction with the MAPS outlined in other
sections of this Practice. They will facilitate ease of replacement of
component parts.
El.02 The basic synopsis of this Appendix is that if a component part
has been judged to be defective by the use of the MAPS,
replace it.
TABLE El-l
SX-200 MECHANICAL PROCEDURE
Title
Replace Console and/or Console Cable
Replace Interconnect Card
Replace Power Fail Transfer Card
Replace Console Interface Card
Replace First or Second Shelf
Replace Heat Sink Assembly
Replace Power Supply Assembly
Replace Reserve Battery Backup Supply
Replace Backplane Translator Board
Replace Cards in Shelf
Replace Maintenance Panel
Replace Wiring Harness
Reference
MAP350-50 1
MAP350-502
MAP350-503
MAP350-504
MAP350-505
MAP350-506
MAP350-507
MAP350-508
MAP350-509
MAP350-510
MAP350-5 11
MAP350-512
Page E-1/2
To Next Page