Mitsubishi 4G1 series General Information

4G1 ENGINE (E–W) – Crankshaft and Cylinder Block
11A-12-2
PWEE9520
E
Nov. 1995Mitsubishi Motors Corporation
Removal steps
"FA 1. Flywheel bolt
2. Flywheel
3. Flywheel bolt
4. Adapter plate
5. Flywheel
6. Adapter plate
7. Crankshaft bushing
8. Drive plate bolt
9. Adapter plate
10. Drive plate
11. Crankshaft bushing
12. Rear plate
13. Bell housing cover
"DA 14. Rear oil seal
"EA 15. Rear oil seal case
16. Rear oil seal case gasket
"CA 17. Bearing cap bolt
"CA 18. Bearing cap
"BA 19. Crankshaft bearing (lower)
20. Crankshaft
"BA 21. Crankshaft bearing (upper)
AA""AA 22. Oil pressure switch
23. Knock sensor
<4G13 (SOHC 16-VALVE) for
Europe, 4G18 for GCC and 4G18
for Europe (From 2004 model)>
24. Cylinder block
Caution
On the flexible flywheel equipped engines, do not remove any of the bolts “A” of the flywheel
shown in the illustration.
The balance of the flexible flywheel is adjusted in the assembled condition. Removing the bolt,
therefore, can cause the flexible flywheel to be out of balance, giving damage to the flywheel.
PWEE9520-G
E
Apr. 2003Mitsubishi Motors Corporation Revised

Mitsubishi 4G1 series Specifications

General

Brand	Mitsubishi
Model	4G1 series
Category	Engine
Language	English