11-94
Installation procedure
Installation: Oil spray plug
• Install the oil spray plug in the illustrated direction.
CAUTION
• Be careful that if the direction of the oil spray plug is not ap-
propriate, oil supply to the timing gear becomes insuffi-
cient, causing seizure.
Installation: Gasket
• Lower parts of the gasket (oil pan mounting surface) protrude af-
ter installation. Cut the protruding parts after installing the fly-
wheel housing.
Installation: Crankshaft gear
• Heat the crankshaft gear to approximately 100°C with a burner
or the like.
WARNING
• You may burn yourself if you touch the heated crankshaft
gear.
• Align the locating pin fitted in the crankshaft with the notch in the
crankshaft gear. Drive the gear into position by lightly striking its
end face with a plastic hammer.
Installation: Rear oil seal slinger
• Install the rear oil seal slinger so that it is in close contact with
the crankshaft gear.
Installation: Ring
• To install the ring, push it in with until it comes into positive
contact with the slinger end face.
CRANKSHAFT AND CRANKCASE
To Next Page
Loading...
