15-40
Removal: Snap ring
• Tighten the bolt to contract the snap ring and remove the ring.
Removal: Compressor cover
• Lightly tap around the entire periphery of the compressor cover
with a rubber-faced hammer, taking care not to cause damage.
CAUTION
• The blades on the cartridge assembly are easily bent. Make
sure that they do not strike the compressor cover.
Removal: Turbine housing
• Lightly tap around the entire periphery of the turbine housing
with a rubber-faced hammer, taking care not to cause damage.
CAUTION
• The blades of the turbine wheel on the cartridge assembly
are easily bent. Make sure that they do not strike the turbine
housing.
Work after disassembly
Cleaning
• Before cleaning, visually check the disassembled parts for
scorches, abrasion and other marks that may be difficult to see
after cleaning. Replace any part that appears de
fective.
• Immer
se the disassembled parts in a non-flammable solvent (a
5 to 10 aqueous solution of Oil Clean from New Hope Co., Ltd.).
Take out the parts and blow them dry with compressed air. Re-
move any hard deposits with a stiff brush or plastic scraper.
• Again, immerse the parts in the solvent.
• Blow them dry using compressed air.
Inspection procedure
Inspection: Spacer outside diameter
• If the measurement is less than the specified limit, replace the
spacer.
TURBOCHARGER
To Next Page
Loading...
