FX Series Positioning Controllers Program format 5
5-22
When the vector speed (f) is omitted, the machine operates at the following speed.
(The value is not same PARA.4 (maximum speed))
When interpolation instructions are consecutively executed, path operation is performed.
In the FX
2N
-10GM, multistep operation is performed (Refer to Section 5.4.3).
Program example
cod91 (INC) ; Incremental drive
cod91 (LIN)
x1000
y500
f2,000;
Table 5.12: Vector speed (f)
10GM 20GM
1st time 200kHz 100kHz
2nd time or Later Previous f value
Y axis
X axis
500
Y axis travel
1000
X axis travel
To Next Page
Loading...
