Mitsubishi FX2N-10GM - Parameter Recording

FX Series Positioning Controllers Appendix 12
12-3
12.2 Parameter recording
Table 12.2: Positioning parameters
PARA No. Description X axis set value Y axis set value
0 System of units
1 Pulse rate
2 Feed rate
3 Minimum command unit
4 Maximum speed
5 JOG speed
6 Bias speed
7 Backlash compensation
8 Acceleration time
9 Deceleration time
10 Interpolation time constant
11 Pulse output format
12 Rotation direction
13 Zero return direction
14 Creep speed
15 Zero return direction
16 Machine zero point address
17 Zero point signal count
18 Zero point signal count start timing
19 DOG switch input logic
20 Limit switch logic
21 Error evaluation time
22 Servo ready check
23 Stop mode
24 Electrical zero point address
25 Software limit (upper)
26 Software limit (lower)