FX Series Positioning Controllers Introduction 1
1-25
1.7.2 I/O specifications of terminal block (AC input type)
1.7.3 Output specifications of terminal block
Other general specifications are equivalent to those of the positioning unit.
Table 1.4: I/O specifications of terminal block (AC input type
)
Model FX-16E-A1-TB (AC input type)
Input signal voltage 100 to 120V AC+10%-15%, 50/60 Hz
Input signal current 6.2 mA / 110V AC, 60 Hz or 4.7 mA / 100V AC, 50 Hz
Input ON current 3.8 mA / 80V AC
Input OFF current 1.7 mA / 30V AC
Response time 25 to 30 ms (Intake at high speed is not possible.)
Input signal type Contact with voltage
Circuit insulation Photocoupler insulation
Input operation indication No input LED (Only 24 V power LED is provided.)
Input impedance Approx. 21 K
Ω
/ 50 Hz or 18 K
Ω
/ 60 Hz
Current consumption 3 mA / 24V DC at each point
Table 1.5: Output specifications of terminal block
Model
FX-16EYR-TB
(relay output)
FX-16EYS-TB
(TRIAC output)
FX-16EYT-TB
(transistor output)
FX-16EYT-H-TB
(transistor output)
Load voltage
250V AC / 30V DC
or less
85V AC to 242V
AC
5V DC to 30V DC 5V DC to 30V DC
Circuit insulation
Mechanical insula-
tion
Photothyristor
insulation
Photocoupler insu-
lation
Photocoupler insu-
lation
Operation indica-
tion
While power is
supplied to relay
coil, LED is lit.
While power is
supplied to photo-
thyristor, LED is lit.
While power is sup-
plied to photocou-
pler, LED is lit.
While power is sup-
plied to photocou-
pler, LED is lit.
Maximum load
Resis-
tance load
2 A / point
8 A / 4 points
0.3 A / point
0.8 A / 4 points
0.5 A / point
0.8 A / 4 points
1 A / point
3 A / 4 points
Inductive
load
80 VA
15VA / 100V AC
30VA / 200V AC
12W / 24V DC 24W / 24V DC
Ramp load 100W 30W 1.5W / 24V DC 3W / 24V DC
Closed circuit
leak current
1mA / 100V AC
2mA / 200V AC
0.1mA / 30V DC 0.1mA / 30V DC
Minimum load
5 VDC, 2 mA (ref-
erence values)
0.4VA / 100V AC
1.6VA / 200V AC
Response
time
OFF
→
ON Approx. 10 ms 2 ms or less 0.2 ms or less 0.3 ms or less
ON
→
OFF Approx. 10 ms 12 ms or less 1.5 ms or less 4 ms or less
Input signal cur-
rent
5mA / 24V DC at
each point (current
consumption)
7mA / 24V DC at
each point (current
consumption)
7mA / 24V DC at
each point (current
consumption)
7mA / 24V DC at
each point (current
consumption)
To Next Page
Loading...
