Mitsubishi FX2N-10GM - Terminal Block Layout

FX Series Positioning Controllers Introduction 1
1-31
1.7.5 Terminal block layout
The terminal layout in the terminal block varies depending on the connector of the connected
positioning unit or extension block. Major terminal layout combinations are shown below.
In any cases not shown below, assign the terminal layout while referring to "1.7.4 Internal con-
nection diagram of terminal block".
When connecting a flat cable, make sure to align the direction of a protrusion on each connec-
tor as shown below.
CON1 in FX
2N
-10GM
→
FX-16E-TB (connected with FX-16E-
{{{
CAB)
CON1 in FX
2N
-20GM
→
FX-16E-TB (connected with FX-16E-
{{{
CAB)
CON2 in FX
2N
-20GM
→
FX-16E-TB (connected with FX-16E-
{{{
CAB)
CON2 in FX
2N
-10GM or CON3 in FX
2N
-20GM
→
FX-16E-TB (connected with E-GM-200CAB)
CON4 in FX
2N
-20GM
→
FX-16E-TB (connected with E-GM-200CAB)
Protrusion
Protrusion Protrusion
Protrusion
Y05 COM1STOP FWD COM1 DOG LSR COM1 X01 X03 COM1 Y01 Y03
Y04 COM1
START ZRN COM1 RVS LSF COM1 X00 X02 COM1 Y00 Y02
COM1Y01 Y03 COM1 Y05 Y07 COM1 X01 X03 COM1 X05 X07
COM1Y00 Y02 COM1 Y04 Y06 COM1 X00 X02 COM1 X04 X06
yx
START COM1 ZRN COM1 RVS LSFLFSRVSCOM1ZRN START COM1
STOPCOM1 FWD COM1 DOG LSRLSRDOGCOM1FWDSTOP COM1
yxyxyxyxyx
yyyyyyxxxxxx
x
SVEND COM5 PG0 COM5 VINVINCOM5ST1 SVRDY COM5
COM2COM5 COM4 COM5 RP VINVINFPCOM5ST2 COM2 COM5
xxxxxx
xxxxxxx
COM3
CLR
x
x
x
x
x
x
x
x
x
x
x
x
SVEND COM9 PG0 COM9 VINVINCOM9ST3 SVRDY COM9
COM6COM9 COM8 COM9 RP VINVINFPCOM9ST4 COM6 COM9COM7
CLR
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y
y